Users Guide

vrrp-group
Assign a VRRP ID to an interface. You can configure up to 12 VRRP groups per interface.
Syntax
vrrp-group vrrp-id
Parameters
vrrp-id Enter a number as the group ID. The range is from 1 to 255.
Defaults Not configured.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
The VRRP group only becomes active and sends VRRP packets when you configure a virtual IP address.
When you delete the virtual IP address, the VRRP group stops sending VRRP packets.
Related
Command
● virtual-address — assigns up to 12 virtual IP addresses per VRRP group.
version
Set the VRRP protocol version for the IPv4 group.
Syntax
version {2 | 3 | both}
To return to the default setting, use the no version command.
Parameters
2 Enter the keyword 2 to specify VRRP version 2 as defined by RFC 3768, Virtual
Router Redundancy Protocol.
3 Enter the keyword 3 to specify VRRP version 3 as defined by RFC 5798, Virtual
Router Redundancy Protocol.
both Enter the keyword both for in-service migration from VRRP version 2 to VRRP
version 3.
Defaults 2
Command Modes VRRP
1486 Virtual Router Redundancy Protocol (VRRP)