Users Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

1471

Table Of Contents

Parameters

priority

Enter a number as the priority. Enter 255 only if the router’s virtual address is the

same as the interface’s primary IP address (that is, the router is the OWNER). The

range is from 1 to 255. The default is 100.

Defaults 100

Command Modes VRRP

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.16.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.2.1.1 Introduced on the E-Series.

Usage

Information

To guarantee that a VRRP group becomes MASTER, configure the VRRP group’s virtual address with

same IP address as the interface’s primary IP address and change the priority of the VRRP group to 255.

If you set the priority command to 255 and the virtual-address is not equal to the interface’s

primary IP address, an error message appears.

show config

View the non-default VRRP configuration.

Syntax

show config [verbose]