Users Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

1421

Table Of Contents

Commands

● vlan-stack compatible — enables stackable VLAN on a VLAN.

stack-unit stack-group

Configure a stacking group specified by an ID.

Syntax

[no] stack-unit unit-id stack-group stack-group-id

To remove the current stack group configuration, use the no stack-unit unit-id stack-group

stack-id command.

Parameters

unit-id

Enter the stack unit ID.

stack-group-id

Enter the stack group ID. The range is from 0 to 16.

Command Modes CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.10.2 Introduced on the S4810.

Usage

Information

NOTE: The following message displays to confirm the command: All non-default

configurations on the related member ports ports (<ports listed here>)

will be removed. Do you want to continue (y/n)? If you enter “y”, all non-default

configurations on any member ports of the current stack group are removed when you reboot the

unit.

vlan-stack access

Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.

Syntax

vlan-stack access

To remove access port designation, use the no vlan-stack access command.

Defaults Not configured.

Command Modes INTERFACE