Users Guide

Example
Dell(conf)# uplink-state-group 16
Dell(conf)#
02:23:17: %RPM0-P:CP %IFMGR-5-ASTATE_UP: Changed uplink state group
Admin state to up: Group 16
Dell(conf)#
Related
Commands
● show running-config uplink-state-group — displays the current configuration of one or more uplink-
state groups.
● show uplink-state-group — displays the status information on a specified uplink-state group or all
groups.
upstream
Assign a port or port-channel to the uplink-state group as an upstream interface.
Syntax
upstream interface
To delete an uplink-state group, use the no upstream interface command.
Parameters
interface Enter one of the following interface types:
● 1 Gigabit Ethernet: gigabitethernet {slot/port | slot/port-
range}
● 10 Gigabit Ethernet: tengigabitethernet {slot/port | slot/port-
range}
● Port channel: port-channel {1–128 | port-channel-range}
Where port-range and port-channel-range specify a range of ports
separated by a dash (-) and/or individual ports/port channels in any order; for
example: gigabitethernet 1/1-2,5,9,11-12 port-channel 1-3,5. A
comma is required to separate each port and port-range entry.
Defaults none
Command Modes UPLINK-STATE-GROUP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.4.2.3 Introduced on the S-Series S50.
Usage
Information
You can assign physical port or port-channel interfaces to an uplink-state group.
You can assign an interface to only one uplink-state group. Configure each interface assigned to an
uplink-state group as either an upstream or downstream interface, but not both.
You can assign individual member ports of a port channel to the group. An uplink-state group can contain
either the member ports of a port channel or the port channel itself, but not both.
Uplink Failure Detection (UFD) 1423