Users Guide

Version Description
7.5.1.0 Introduced on the C-Series and added support for IPv6 address on the E-Series
only.
Usage
Information
The VRF configured using this command has a higher precedence than a VRF configured using the ip
telnet vrf vrf-name command. If you do not use the VRF attribute in this command, then TELENT
client uses the VRF configured using the ip telnet vrf vrf-name command.
The source interface configured using this command has a higher precedence than the source interface
configured using the ip telnet source-interface command. If you do not configure a source
interface using this command, then the TELNET client uses the source interface configured using the ip
telnet source-interface command.
In case there is a mismatch between the VRF telnet source interface and the telnent VRF, then an error is
reported.
Example
Dell# telnet vrf vrf1 10.10.10.2
telnet-peer-stack-unit
Open a Telnet connection to the peer stack unit.
Syntax
telnet-peer-stack-unit
Defaults Not configured.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S-Series.
terminal length
Configure the number of lines displayed on the terminal screen.
Syntax
terminal length screen-length
140 Control and Monitoring