Users Guide

storm-control multicast (Interface)
Configure the percentage of multicast traffic allowed on an C-Series or S-Series interface (ingress only) network only.
Syntax
storm-control multicast packets_per_second in
To disable multicast storm control on the interface, use the no storm-control multicast
packets_per_second in command.
Parameters
packets_per_sec
ond in
Enter the packets per second of broadcast traffic allowed into the network. The
range is from 0 to 33554368.
Defaults none
Command Modes INTERFACE (conf-if-interface-slot/port)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the C-series and S-Series.
storm-control unknown-unicast (Configuration)
Configure the percentage of unknown-unicast traffic allowed in or out of the network.
Syntax
storm-control unknown-unicast [packets_per_second in]
To disable storm control for unknown-unicast traffic, use the no storm-control unknown-
unicast [packets_per_second in] command.
Parameters
packets_per_sec
ond in
Enter the packets per second of broadcast traffic allowed into the network. The
range is from 0 to 33554368.
Defaults none
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
Storm Control 1371