Users Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

1341

Table Of Contents

Command Modes SPANNING TREE

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.7.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.2.1.1 Introduced on the E-Series.

Commands

● forward-delay — changes the wait time before STP transitions to the Forwarding state.

● max-age — changes the wait time before STP refreshes protocol configuration information.

max-age

To maintain configuration information before refreshing that information, set the time interval for the spanning tree bridge.

Syntax

max-age seconds

To return to the default values, use the no max-age command.

Parameters

seconds

Enter a number of seconds the Dell Networking OS waits before refreshing

configuration information. The range is from 6 to 40. The default is 20 seconds.

Defaults 20 seconds