Users Guide

Version Description
E-Series legacy
command
Usage
Information
To block a type of message parameter, set the logging trap level to a lower number. For example, to block
severity messages at level 6, set the level to 5.
Related
Commands
● logging — enables the logging to another device.
● logging on — enables logging.
logging version
Displays syslog messages in a RFC 3164 or RFC 5424 format.
Syntax
logging version {0|1}
Defaults
0
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
Usage
Information
To display syslog messages in a RFC 3164 or RFC 5424 format, use the log version command in
configuration mode. By default, the system log version is set to 0.
The following describes the two supported log messages formats:
● 0 – Displays syslog messages format as described in RFC 3164, The BSD syslog Protocol
● 1 – Displays SYSLOG message format as described in RFC 5424, The Syslog Protocol
Example
Dell(conf)#logging version ?
<0-1> Select syslog version (default = 0)
Dell(conf)#logging version 1
show logging
Display the logging settings and system messages logged to the internal buffer of the switch.
Syntax
show logging [number | history [reverse][number] | reverse [number] |
summary]
Parameters
number (OPTIONAL) Enter the number of messages displayed in the output. The range is
from 1 to 65535.
1332 Simple Network Management Protocol (SNMP) and Syslog