Users Guide

Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
snmp-server enable traps
Enable SNMP traps.
Syntax
snmp-server enable traps [notification-type] [notification-option]
To disable traps, use the no snmp-server enable traps [notification-type]
[notification-option] command.
Parameters
notification-type Enter the type of notification from the following list:
● bgp — Notification of changes in the BGP process.
● config — Notification of changes to the startup or running configuration.
● ecfm — Notification of changes to ECFM.
● ecmp — Enable an ECMP trap to notify of ECMP or link bundle traffic
imbalances.
● envmon — For Dell Networking device notifications when an environmental
threshold is exceeded.
● isis — Notification of intermediate service traps.
● lacp — Notification of changes.
●
snmp — Notification of RFC 1157 traps.
● stp — Notification of a state change in the spanning tree protocol (RFC 1493).
● vlt — Notification of virtual link trunking.
● vrrp — Notification of a state change in a VRRP group.
● xstp — Notification of a state change in MSTP (802.1s), RSTP (802.1w), and
PVST+.
notification-
option
For the envmon notification-type, enter one of the following optional parameters:
● cam-utilization
● fan
● supply
● temperature
For the snmp notification-type, enter one of the following optional parameters:
● authentication
● coldstart
● linkdown
● linkup
● syslog-reachable
● syslog-unreachable
Defaults Not enabled.
Command Modes CONFIGURATION
1302 Simple Network Management Protocol (SNMP) and Syslog