Users Guide

Usage
Information
When you enable VLAN-Stacking, no protocol packets are tunneled.
Related
Command
● show protocol-tunnel — displays tunneling information for all VLANs.
protocol-tunnel enable
Enable protocol tunneling globally on the system.
Syntax
protocol-tunnel enable
To disable protocol tunneling, use the no protocol-tunnel enable command.
Defaults Disabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.4.1.0 Introduced
Usage
Information
Dell Networking OS must have the default CAM profile with the default microcode before you enable
L2PT.
protocol-tunnel rate-limit
Enable traffic rate limiting per box.
Syntax
protocol-tunnel rate-limit rate
To reset the rate limit to the default, use the no protocol-tunnel rate-limit rate command.
Parameters
rate Enter the rate in frames per second. The range is from 75 to 3000. The default is
75.
Defaults 75 frames per second.
Command Modes CONF-IF-VLAN-STACK
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
1282 Service Provider Bridging