Users Guide

Power over Ethernet (PoE)
Dell Networking OS supports Power over Ethernet (PoE) and Power over Ethernet Plus (PoE+) on S3100 series systems.
Use the commands in this chapter to configure the Power over Ethernet (PoE) on the S3100 platforms.
Topics:
• advertise dot3-tlv
• advertise med power-via-mdi
• power budget global-threshold
• power inline
• power inline legacy
• power inline mode
• power inline restore
• power inline suspend
• show power detail
• show power inline
advertise dot3-tlv
Advertise dot3 TLVs (Type, Length, Value).
S3100 series
Syntax
advertise dot3-tlv {max-frame-size | power-via-mdi}
To remove advertised dot3-tlv, use the no advertise dot3-tlv {max-frame-size | power-
via-mdi} command.
Parameters
max-frame-size Enter the keywords max-frame-size to advertise the dot3 maximum frame size
TLV.
power-via-mdi Enter the keyword power—via-mdi to advertise IEEE 802.3 at power-via-mdi
TLV.
Defaults None
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
41
Power over Ethernet (PoE) 1059