Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

971

972

973

974

975

976

977

978

979

980

device–role

Specify the role of the device attached to the port.

Syntax

device-role {host | router}

To reset the device role, use the no device-role {host | router} command.

Parameters

host Enter the keyword host to set the device-role as host.

router Enter the keyword router to set the device-role as router.

Defaults None

Command Modes POLICY LIST CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.11(0.0) Introduced on the C9010.

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100-ON.

9.9(0.0) Introduced on the Z9500.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON, and Z9000 switches.

Commands

• ipv6 nd raguard policy policy-name — define the RA guard policy name and enter the RA guard policy

configuration mode.

• ipv6 nd ra-guard enable — configure the RA guard related commands.

hop–limit

Enable the verification of the advertised hop count limit. If this command is not configured, the verification process is bypassed.

Syntax

hop-limit {maximum | minimum limit}

To reset the hop count limit, use the no hop-limit {maximum | minimum limit} command.

Parameters

maximum

limit

Enter the keyword maximum then the hop limit value. The range is from 0 to 254.

minimum