Administrator Guide

If you enabled BMP, to perform a reload on the chassis to upgrade any configuration changes that have changed
the NVRAM content, use the reload conditional nvram-cfg-change command.
cam-acl-vlan
Specify the number of VFP blocks allocated to OpenFlow.
Syntax
cam-acl-vlan {default | vlanopenflow {0|1}}
Defaults Disabled.
Parameters
default Reset VLAN CAM ACL entries to default settings
vlanopenflow Enter the number 1 to allocate VFP blocks and enable OpenFlow.
(Default) Enter the number 0 to disable OpenFlow.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.1.(0.0) Introduced on S4810.
8.3.19.0 Introduced on the S4820T.
Usage Information
Reboot the switch after changing the parameter values for changes to take effect.
For platform-specific instructions about using this command, see the SDN section of the Dell EMC Networking
OS Configuration Guide.
clear average-power
Reset the average power and average power start time.
Syntax
clear average-power stack-unit {stack-unit-number}
Parameters
stack-unit-number Enter the stack unit number.
Defaults None
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.11(2.1P1) Introduced on all Dell EMC Networking OS platforms
Usage Information
This command resets the average power and average power start time to the current time. Average power and
average power start time will be calculated from the reset time (i.e current time).
Control and Monitoring 87