Administrator Guide

Version Description
7.6.1.0 Introduced on the S-Series.
show mac-address-table
Display the MAC address table.
Syntax
show mac-address-table [address mac-address | interface interface | vlan vlan-
id] [aging-time] [dynamic | static] [count [vlan vlan-id] [interface interface-
type [slot [/port]]]]
Parameters
address mac-
address
(OPTIONAL) Enter the keyword address then a MAC address in the nn:nn:nn:nn:nn:nn
format to display information on that MAC address.
dynamic (OPTIONAL) Enter the keyword dynamic to display only those MAC addresses the
switch dynamically learns. Optionally, you can also add one of these combinations:
address/mac-address, interface/interface, or vlan vlan-id.
static (OPTIONAL) Enter the keyword static to display only those MAC addresses
specifically configured on the switch. Optionally, you can also add one of these
combinations: address/mac-address, interface/interface, or vlan vlan-
id.
aging-time Enter the keyword aging-time to display only aging-time information.
interface interface (OPTIONAL) Enter the keyword interface and the interface information:
• For a port channel interface, enter the keywords port-channel then a number.
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
interface
interface-type
(OPTIONAL) Instead of entering the keyword interface then the interface type, slot/
port information, as above, you can enter the interface type, then just a slot number.
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the VLAN ID to display the MAC address
assigned to the VLAN. The range is 1 to 4094.
count (OPTIONAL) Enter the keyword count, then optionally, by an interface or VLAN ID, to
display total or interface-specific static addresses, dynamic addresses, and MAC
addresses in use.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
Layer 2 865