Administrator Guide

Version Description
8.3.7.0 Introduced on the S4810.
ipv6 flowlabel-zero
Configure system to set the flow label field in the packets to zero.
Syntax
ipv6 flowlabel-zero
To disable the 0 from being set in the field and allow the protocol operations to fill the field, use the no ipv6
flowlabel-zero command.
Default Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant DellEMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information If the flowlabel value is already set for BGP or SSH, the system defaults to the already configured value. All
packets on the same connection are considered part of the same flow by the system. For new connections, set
the new flowlabel to zero.
ipv6 host
Assign a name and IPv6 address the host-to-IPv6 address mapping table uses.
Syntax
ipv6 host name ipv6-address
To remove an IP host, use the no ipv6 host name {ipv6–address}.
Parameters
name Enter a text string to associate with one IP address.
ipv6-address Enter the IPv6 address (X:X:X:X::X) to be mapped to the name.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3148.
762 IPv6 Basics