Administrator Guide

Version Description

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced.

Usage Information

This command applies to both IPv4 and IPv6 CAM Profiles, but is best used when verifying QoS optimization for

IPv6 ACLs.

QoS Optimization for IPv6 ACLs does not impact the CAM usage for applying a policy on a single (or the first of

several) interfaces. It is most useful when a policy is applied across multiple interfaces; it can reduce the impact to

CAM usage across subsequent interfaces.

The following describes the test cam-usage command shown in the following example.

Term Explanation

Stack-Unit

Lists the stack unit or units that are checked. Entering all shows the status for all stacks.

Portpipe Lists the portpipe (port-set) or port pipes (port-sets) that are checked. Entering all

shows the status for stack-units and port-pipes in the chassis. The port set value is from

0 to 0.

CAM Partition Shows the CAM profile of the CAM.

Available CAM Identifies the amount of CAM space remaining for that profile.

Estimated CAM

per Port

Estimates the amount of CAM space the listed policy will require.

Status Indicates whether or not the policy will be allowed in the CAM.

Example

DellEMC# test cam-usage service-policy input In stack-unit all

----------------------------------------------------------------------------

1 | 0 | IPv4Flow | 102 | 0| Allowed

DellEMC#

DellEMC# test cam-usage service-policy input In stack-unit 1 port-set 0

-----------------------------------------------------------------------------

1 | 0 | IPv4Flow | 102 | 0| Allowed

DellEMC#

Example

454 Content Addressable Memory (CAM)