Administrator Guide

Version Description
7.6.1.0 Introduced on the C-Series and S-Series.
Usage Information Enable the stackable VLAN (using the vlan-stack compatible command) on the VLAN prior to adding a
member to the VLAN.
Related
Commands
• vlan-stack compatible — enables stackable VLAN on a VLAN.
stack-unit stack-group
Configure a stacking group specified by an ID.
Syntax
[no] stack-unit unit-id stack-group stack-group-id
To remove the current stack group configuration, use the no stack-unit unit-id stack-group
stack-id command.
Parameters
unit-id Enter the stack unit ID.
stack-group-id Enter the stack group ID. The range is from 0 to 16.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.10.2 Introduced on the S4810.
Usage Information
CAUTION: The following message displays to confirm the command: All non-default
configurations on the related member ports ports (<ports listed here>) will
be removed. Do you want to continue (y/n)? If you enter “y”, all non-default
configurations on any member ports of the current stack group are removed when you reboot the
unit.
vlan-stack access
Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.
Syntax
vlan-stack access
To remove access port designation, use the no vlan-stack access command.
Defaults Not configured.
1574 VLAN Stacking