Administrator Guide
Version Description
6.2.1.1 Introduced on the E-Series.
Usage Information
You can configure up to two sFlow collectors (IPv4 or IPv6). If two collectors are configured, traffic samples are
sent to both.
The sFlow agent address is carried in a field in SFlow packets and is used by the collector to identify the sFlow
agent.
In sFlow, the agent address is a single invariant IPv4 or IPv6 address used to identify the agent to the collector. It
is usually assigned the address of a loopback interface on the agent, which provides invariance. The agent address
is carried as a field in the payload of the sFlow packets.
As part of the sFlow-MIB, if the SNMP request originates from a configured collector, Dell EMC Networking OS
returns the corresponding configured agent IP in the MIB requests. Dell EMC Networking OS checks to ensure
that two entries are not configured for the same collector IP with a different agent IP. Should that happen, Dell
EMC Networking OS generates the following error: %Error: Different agent-addr attempted for
an existing collector.
Example
DellEMC(conf)# sflow collector 10.1.1.25 agent-addr 10.1.1.10 vrf management
sflow enable (Global)
Enable sFlow globally.
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced S-Series Stacking.
8.1.1.0 Introduced on the E-Series.
7.7.1.0 Introduced on the S-Series.
sFlow 1413