Administrator Guide

high -
DellEMC#
power inline legacy
Use this command to allocate inline power to the legacy devices on the specified stack unit.
Syntax
power inline legacy stack-unit unit number
To disable the detection of legacy powered devices in a stack unit, use the no power inline legacy
stack-unit unit number command.
Parameters
stack-unit unit
number
Enter the keyword stack-unit and the unit number. Range is 1 to 12.
Defaults Enabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant DellEMC
Networking OS Command Line Reference Guide.
The following is a list of the DellEMC Networking OS version history for this command.
Version Description
9.10(0.0) Introduced on the S3148.
9.10(0.0) Increased the stacking range to 12 units in S3100 series.
9.8(2.0) Introduced on the S3100 series.
Usage Information
The power inline legacy command allows the system to detect and allocate inline power to the legacy
devices on a stack unit.
Example
Dell(conf)#power inline legacy stack-unit 1
power inline mode
Use this command to configure PoE power management mode for a specified stack member.
Syntax
power inline mode stack-unit unit number { class | static }
Parameters
stack-unit unit
number
Enter the keyword stack-unit and the unit number. Range is 1 to 12.
class Enter the keyword class to configure the class mode for the specified stack unit.
static Enter the keyword static to configure the static mode for the specified stack unit.
Defaults Static
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant DellEMC
Networking OS Command Line Reference Guide.
The following is a list of the DellEMC Networking OS version history for this command.
Version Description
9.10(0.0) Introduced on the S3148.
9.10(0.0) Increased the stacking range to 12 units in S3100 series.
Power over Ethernet (PoE) 1163