Administrator Guide
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series.
7.5.1.0 Introduced on the E-Series.
redirect
Configure a rule for the redirect list.
Syntax
redirect {ip-address | slot/port} | tunnel tunnel-id}[track <obj-id>] {ip-
protocol-number | protocol-type [bit]} {source mask | any | host ip-address}
{destination mask | any | host ip-address} [operator]
To remove this filter, use one of the following:
• Use the no seq sequence-number command if you know the filter’s sequence number.
• You can also use the no redirect {ip-address | slot/port}| tunnel tunnel-id}[track
<obj-id>] {ip-protocol-number [bit] | protocol-type} {source mask | any |
host ip-address} {destination mask | any | host ip-address} [operator]
command.
Parameters
redirect Enter the keyword redirect to assign the sequence to the redirect list.
ip-address
Enter the IP address of the forwarding router.
slot/port
Enter the keyword slot / port followed by the slot/port information.
tunnel
Enter the keyword tunnel to configure the tunnel setting.
tunnel-id
Enter the keyword tunnel-id to redirect the traffic.
track
Enter the keyword track to enable the tracking.
track <obj-id>
Enter the keyword track <obj-id> to track object-id.
ip-protocol-
number
Enter a number from 0 to 255 for the protocol identified in the IP protocol header.
protocol-type
Enter one of the following keywords as the protocol type:
• icmp for internet control message protocol
• ip for any internet protocol
• tcp for transmission control protocol
• udp for user datagram protocol
bit
(OPTIONAL) For the TCP protocol type only, enter one or a combination of the following
TCP flags:
• ack = acknowledgement
• fin = finish (no more data from the user)
• psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent field
source
Enter the IP address of the network or host from which the packets were sent.
mask
Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all traffic is subject to the filter.
1114 Policy-based Routing (PBR)