Administrator Guide

The Layer2 PBR option matches the layer2 traffic flow. If you un-configure this option, then the Layer2 traffic is
not matched. You can apply the l2–switch option to redirect Layer2 traffic only on a VLAN interface. This
VLAN interface must be configured with an IP address for ARP resolution.
NOTE: The l2–switch option that redirects Layer2 traffic is applicable only on VLAN interfaces.
The Layer3 routing is not affected on the same interface on which Layer2 PBR is applied. The port from which
Layer2 packets egress and the destination MAC are re-written from static ARP. Layer 2 packets with the re-
written destination MAC are forwarded through the outgoing port on the same incoming VLAN interface. The l2-
switch option ensures that the outgoing VLAN and MAC-SA are changed and TTL is not decremented.
Related
Commands
• show cam pbr – display the content of the PBR CAM.
• show ip redirect-list – display the redirect-list configuration.
ip redirect-list
Configure a redirect list and enter REDIRECT-LIST mode.
Syntax
ip redirect-list redirect-list-name
To remove a redirect list, use the no ip redirect-list command.
Parameters
redirect-list-name Enter the name of a redirect list.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series.
6.5.3.0 Introduced on the E-Series.
permit
Configure a permit rule. A permit rule excludes the matching packets from PBR classification and routes them using conventional routing.
Syntax
permit {ip-protocol-number | protocol-type} {source mask | any | host ip-
address} {destination mask | any | host ip-address} [bit] [operators]
1112 Policy-based Routing (PBR)