Users Guide

2 1 up up 6956 up 7058
3 1 up up 7164 up 7058
4 1 up up 7058 up 7164
5 1 up up 7058 up 6956
6 1 up up 7058 up 7164
7 1 up up 12307 down 0
8 1 up up 7164 up 7164
9 1 up up 7058 up 7058
10 1 up up 7164 up 7058
11 1 up up 7058 up 7058
12 1 up up 7164 up 7058
Speed in RPM
Dell#
Add Units to an Existing Stack
You can add units to an existing stack in one of three ways.
• By manually assigning a new unconfigured unit a position in an existing stack.
• By adding a configured unit to an existing stack.
• By merging two stacks.
If you are adding units to an existing stack, you can either:
• allow Dell Networking OS to automatically assign the new unit a position in the stack, or
• manually determine each units position in the stack by configuring each unit to correspond with the stack before
connecting it.
• If you add a unit that has a stack number that conflicts with the stack, the stack assigns the first available stack number.
• If the stack has a provision for the stack-number that will be assigned to the new unit, the provision must match the unit
type, or Dell Networking OS generates a type mismatch error.
After the new unit loads, it synchronizes its running and startup configurations with the stack.
Manually Assigning a New Unit to an Existing Stack
To manually assign a new unit a position in an existing stack, use the following steps.
1 On the stack, determine the next available stack-unit number, and the management priority of the management unit.
EXEC Privilege mode
show system brief or show system stack-unit
2 On the new unit, number it the next available stack-unit number.
EXEC Privilege mode
stack-unit stack-unit-number renumber stack-unit-new-number
3 (OPTIONAL) On the new unit, assign a management priority based on whether you want the new unit to be the stack
manager.
CONFIGURATION mode
stack-unit stack-unit-number priority priority-number
4 Connect the new unit to the stack using stacking cables.
Example of Adding a Stack Unit with a Conflicting Stack Number (Before and After)
The following example shows adding a stack unit with a conflicting stack number (before).
Dell#show system brief
Stacking 782