Users Guide
RPs advertise each (S,G) in its domain in type, length, value (TLV) format. The total number of TLVs contained in the SA is
indicated in the “Entry Count” field. SA messages are transmitted every 60 seconds, and immediately when a new source is
detected.
Figure 72. MSDP SA Message Format
Topics:
• Anycast RP
• Implementation Information
• Configure Multicast Source Discovery Protocol
• Enable MSDP
• Manage the Source-Active Cache
• Accept Source-Active Messages that Fail the RFP Check
• Specifying Source-Active Messages
• Limiting the Source-Active Messages from a Peer
• Preventing MSDP from Caching a Local Source
• Preventing MSDP from Caching a Remote Source
• Preventing MSDP from Advertising a Local Source
• Logging Changes in Peership States
• Terminating a Peership
• Clearing Peer Statistics
• Debugging MSDP
• MSDP with Anycast RP
• Configuring Anycast RP
• MSDP Sample Configurations
Anycast RP
Using MSDP, anycast RP provides load sharing and redundancy in PIM-SM networks. Anycast RP allows two or more
rendezvous points (RPs) to share the load for source registration and the ability to act as hot backup routers for each other.
Anycast RP allows you to configure two or more RPs with the same IP address on Loopback interfaces. The Anycast RP
Loopback address are configured with a 32-bit mask, making it a host address. All downstream routers are configured to know
that the Anycast RP Loopback address is the IP address of their local RP. IP routing automatically selects the closest RP for each
source and receiver. Assuming that the sources are evenly spaced around the network, an equal number of sources register
with each RP. Consequently, all the RPs in the network share the process of registering the sources equally. Because a source
may register with one RP and receivers may join to a different RP, a method is needed for the RPs to exchange information
about active sources. This information exchange is done with MSDP.
Multicast Source Discovery Protocol (MSDP) 468