Users Guide

• Adjust the maximum response time.
INTERFACE mode
ip igmp query-max-resp-time
• Adjust the last member query interval.
INTERFACE mode
ip igmp last-member-query-interval
Preventing a Host from Joining a Group
You can prevent a host from joining a particular group by blocking specific IGMP reports using an extended access list
containing the permissible source-group pairs.
NOTE
: For rules in IGMP access lists, source is the multicast source, not the source of the IGMP packet. For IGMPv2, use
the keyword any for source (as shown in the following example) because the IGMPv2 hosts do not know in advance who
the source is for the group in which they are interested.
To apply the access list, use the following command.
• Apply the access list.
INTERFACE mode
ip igmp access-group access-list-name
Dell Networking OS Behavior: Do not enter the ip igmp access-group command before creating the access-list. If you do,
after entering your first deny rule, the Dell Networking OS clears the multicast routing table and re-learns all groups, even those
not covered by the rules in the access-list, because there is an implicit
deny all rule at the end of all access-lists. Therefore,
configuring an IGMP join request filter in this order might result in data loss. If you must enter the ip igmp access-group
command before creating the access-list, prevent the Dell Networking OS from clearing the routing table by entering a permit
any rule with a high sequence number before you enter any other rules.
In the following example, virtual local area network (VLAN) 400 is configured with an access list to permit only IGMP reports for
group 239.0.0.1. Though Receiver 2 sends a membership report for groups 239.0.0.1 and 239.0.0.2, a multicast routing table
Internet Group Management Protocol (IGMP) 290