Administrator Guide

○ local2 (for local use)
○ local3 (for local use)
○ local4 (for local use)
○ local5 (for local use)
○ local6 (for local use)
○ local7 (for local use)
○ lpr (for line printer system messages)
○ mail (for mail system messages)
○ news (for USENET news messages)
○ sys9 (system use)
○ sys10 (system use)
○ sys11 (system use)
○ sys12 (system use)
○ sys13 (system use)
○ sys14 (system use)
○ syslog (for syslog messages)
○ user (for user programs)
○ uucp (UNIX to UNIX copy protocol)
To view nondefault settings, use the show running-config logging command in EXEC mode.
DellEMC#show running-config logging
!
logging buffered 524288 debugging
service timestamps log datetime msec
service timestamps debug datetime msec
!
logging trap debugging
logging facility user
logging source-interface Loopback 0
logging 10.10.10.4
DellEMC#
Synchronizing Log Messages
You can configure Dell EMC Networking OS to filter and consolidate the system messages for a specific line by synchronizing
the message output.
Only the messages with a severity at or below the set level appear. This feature works on the terminal and console connections
available on the system.
1. Enter LINE mode.
CONFIGURATION mode
line {console 0 | vty number [end-number] | aux 0}
Configure the following parameters for the virtual terminal lines:
● number: the range is from zero (0) to 8.
● end-number: the range is from 1 to 8.
You can configure multiple virtual terminals at one time by entering a number and an end-number.
2. Configure a level and set the maximum number of messages to print.
LINE mode
logging synchronous [level severity-level | all] [limit]
Configure the following optional parameters:
● level severity-level: the range is from 0 to 7. The default is 2. Use the all keyword to include all messages.
● limit: the range is from 20 to 300. The default is 20.
Management
71