Users Guide

Port-Pipes
A port pipe is a Dell Networking-specic term for the hardware packet-processing elements that handle network trac to and from a set of
front-end I/O ports. The physical, front-end I/O ports are referred to as a
port-set. In the command-line interface, a port pipe is entered
as
port-set port-pipe-number.
Auto-Negotiation on Ethernet Interfaces
By default, auto-negotiation of speed and full duplex mode is enabled on 10/100/1000 Base-T Ethernet interfaces. Only 10GE interfaces do
not support auto-negotiation.
When using 10GE interfaces, verify that the settings on the connecting devices are set to no auto-negotiation.
The local interface and the directly connected remote interface must have the same setting, and auto-negotiation is the easiest way to
accomplish that, as long as the remote interface is capable of auto-negotiation.
NOTE: As a best practice, Dell Networking recommends keeping auto-negotiation enabled. Only disable auto-negotiation on
switch ports that attach to devices not capable of supporting negotiation or where connectivity issues arise from interoperability
issues.
For 10/100/1000 Ethernet interfaces, the negotiation auto command is tied to the speed command. Auto-negotiation is always
enabled when the speed command is set to 1000 or auto.
NOTE: The negotiation auto and the speed commands are not available on the combo ports in the hybrid mode. Provision
the combo port as copper or ber medium using the combo-port-type command.
NOTE:
Setting the Speed of Ethernet Interfaces
To discover whether the remote and local interface requires manual speed synchronization, and to manually synchronize them if necessary,
use the following command sequence.
1 Determine the local interface status. Refer to the following example.
EXEC Privilege mode
show interfaces [interface | stack—unit stack-unit-number] status
2 Determine the remote interface status.
EXEC mode or EXEC Privilege mode
[Use the command on the remote system that is equivalent to the rst command.]
3 Access CONFIGURATION mode.
EXEC Privilege mode
config
4 Access the port.
CONFIGURATION mode
interface interface-type
5 Set the local port speed.
INTERFACE mode
speed {10 | 100 | 1000 | 10000 | auto}
Interfaces
345