Administrator Guide

name
The name you assign to the multiple spanning tree region.
Syntax
name region-name
To remove the region name, use the no name command.
Parameters
region-name Enter the MST region name. The range is 32 character limit.
Defaults No default name.
Command Modes MULTIPLE SPANNING TREE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 Introduced.
Usage
Information
For two MSTP switches to be within the same MSTP region, the switches must share the same region
name (including matching case).
Related
Commands
● msti — map the VLAN(s) to an MST instance.
● revision — assign the revision number to the MST configuration.
port-channel path-cost custom
Sets the path cost to be constant for port-channel regardless of its operation status.
Syntax
port-channel path-cost custom
To change the path cost to comply with new IEEE standard behavior, use no port-channel path-
cost custom command.
Defaults Disabled
Multiple Spanning Tree Protocol (MSTP) 979