Administrator Guide

cp (OPTIONAL) Enter the keyword cp to view only statistics from the Control
Processor.
rp1 (OPTIONAL) Enter the keyword rp1 to view only the statistics from Route
Processor 1.
rp2 (OPTIONAL) Enter the keyword rp2 to view only the statistics from Route
Processor 2.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 F10 Monitoring MIB available for the ip traffic statistics command.
pre-6.1.1.0 Introduced on the E-Series.
Usage
Information
The following describes the show ip traffic summary shown in the following example.
Keyword Definition
unknown
protocol...
No receiver for these packets. Counts packets whose protocol type field is not
recognized by Dell EMC Networking OS.
not a gateway... Packets can not be routed; the host/network is unreachable.
security
failures...
Counts the number of received unicast/multicast packets that could not be
forwarded due to:
● route not found for unicast/multicast; ingress interfaces do not belong to the
destination multicast group
● destination IP address belongs to reserved prefixes; the host/network is
unreachable
bad options... Unrecognized IP option on a received packet.
Frags: IP fragments received.
... reassembled Number of IP fragments that were reassembled.
IPv4 Routing 767