Administrator Guide

to 113.3.3.254
DellEMC#
Related
Commands
● ip helper-address – specify the destination broadcast or host address for the DHCP server request.
● ip helper-address hop-count disable – disable the hop-count increment for the DHCP relay agent.
debug ip icmp
View information on the internal control message protocol (ICMP).
Syntax
debug ip icmp [interface] [count value]
To disable debugging, use the no debug ip icmp command.
Parameters
interface (OPTIONAL) Enter the following keywords and the interface information:
● For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then
the slot/port information.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
count value (OPTIONAL) Enter the keyword count then the count value. The range is from 1
to 65534. The default is Infinity.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4094 VLANs on the E-Series (the prior limit was 2094).
IPv4 Routing 721