Administrator Guide

Example
DellEMC(conf-crypto-policy)# do show crypto ipsec policy
Policy name : pol1
Policy refcount : 0
Sequence Num : 1
SA Mode : IPSEC-MANUAL
Transform-Set Name :
Peer IP Address :
Inbound AH SPI : 0
Inbound ESP Auth SPI : 0
Inbound ESP Encry SPI : 0
Inbound AH Key : [0]::
Inbound ESP Auth Key : [0]::
Inbound ESP Encry Key : [0]::
Outbound AH SPI : 0
Outbound ESP Auth SPI : 0
Outbound ESP Encry SPI: 0
Outound AH Key : [0]::
Outound ESP Auth Key : [0]::
Outound ESP Encry Key : [0]::
Match sequence Num : 2
Protocol type : tcp
IP or IPv6 : IP
Source address : 1.1.1.1
Source mask : /32
Source port : 0
Destination address : 1.1.1.2
Destination mask : /32
Destination port : 23
source-interface name :
source-interface num :
DellEMC(conf-crypto-policy)#
transform-set
Specify the transform set the crypto policy uses.
Syntax
transform-set transform-set-name
To delete a transform set from the crypto policy, use the no transform-set transform-set-
name command.
Parameters
transform-set-
name
Enter the name for the crypto policy transform set.
Defaults None
Command Modes CONFIG-CRYPTO-POLICY
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
706 Internet Protocol Security (IPSec)