Administrator Guide

ah-
authentication
Enter the keywords ah-authentication then the transform type of operation
to apply to traffic. The transform type represents the encryption or authentication
applied to traffic.
● md5 — Use Message Digest 5 (MD5) authentication.
● sha1 — Use Secure Hash Algorithm 1 (SHA-1) authentication.
● null — Causes an encryption policy configured for the area to not be inherited
on the interface.
esp-
authentication
Enter the keywords esp-authentication then the transform type of operation
to apply to traffic. The transform type represents the encryption or authentication
applied to traffic.
● md5 — Use Message Digest 5 (MD5) authentication.
● sha1 — Use Secure Hash Algorithm 1 (SHA-1) authentication.
● null — Causes an encryption policy configured for the area to not be inherited
on the interface.
esp-encryption Enter the keywords esp-encryption then the transform type of operation to
apply to traffic. The transform type represents the encryption or authentication
applied to traffic.
● 3des — Use 3DES encryption.
● cbc — Use CDC encryption.
● des — Use DES encryption.
● null — Causes an encryption policy configured for the area to not be inherited
on the interface.
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
9.2(1.0) Introduced on the Z9500.
Usage
Information
● Both sides of the link must specify the same transform set.
● You can create up to 64 transform sets.
Example
Dell(conf)# do show crypto ipsec transform-set
Transform-Set Name : ts1
Transform-Set refCnt : 0
AH Transform : md5
ESP Auth Transform :
ESP Encry Transform :
Dell(conf)#
Internet Protocol Security (IPSec) 701