Administrator Guide

Version Description
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Restoring factory defaults deletes the existing startup configuration and all persistent settings (stacking,
fan-out, and so forth).
When restoring all units in a stack, all the units in the stack are placed into stand-alone mode.
When restoring a single unit in a stack, that unit placed in stand-alone mode. No other units in the stack
are affected.
When restoring units in stand-alone mode, the units remain in stand-alone mode after the restoration.
After the restore is complete, the units power cycle immediately.
CAUTION: There is no undo for this command.
Following are the factory-default environment variables:
● baudrate
● primary_boot
● secondary_boot
● default_boot
● ipaddr
● gatewayip
● netmask
● macaddr
● mgmtautoneg
● mgmtspeed100
● mgmtfullduplex
Each boot path variable (primary_boot, secondary_boot, and default_boot) is further split into the
following three independent variables:
● primary_server, primary_file, and primary_type
● secondary_server, secondary_file, and secondary_type
● default_server, default_file, and default_type
NOTE:
For information on the default values that these variables take, refer to the Restoring
Factory Default Environment Variables section in the Dell EMC Networking OS Configuration
guide.
Example (all
stack units)
DellEMC# restore factory-defaults stack-unit all clear-all
**************************************************************
* Warning - Restoring factory defaults will delete the existing *
* startup-config and all persistent settings (stacking, fanout, etc.)*
* All the units in the stack will be split into standalone units. *
* After restoration the unit(s) will be powercycled immediately. *
* Proceed with caution ! *
**************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
1 Success Success
2 Success Success
3 Success Success
4 Not present
5 Not present
File Management 69