Administrator Guide

Gi 1/2 Down Auto Auto 1
Gi 1/3 Down Auto Auto 1
Gi 1/4 Down Auto Auto --
Gi 1/5 DellPort Up 1000 Mbit Auto 30-130
Gi 1/6 Down Auto Auto --
Gi 1/7 Down Auto Auto --
Gi 1/8 Up 1000 Mbit Auto 1502,1504,1506-1508,1602
Gi 1/9 Down Auto Auto --
Gi 1/10 Down Auto Auto --
Gi 1/11 Down Auto Auto --
Gi 1/12 Down Auto Auto --
Gi 1/13 Down Auto Auto --
Gi 1/14 Down Auto Auto --
Gi 1/15 Down Auto Auto --
Gi 1/16 Down Auto Auto -DellEMC#
show interfaces switchport
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode interfaces’ IEEE 802.1Q
tag status and VLAN membership.
Syntax
show interfaces switchport [interface-type | stack-unit unit-id ]
Parameters
interface-type (OPTIONAL) Enter one of the following keywords and the interface information:
● For a port channel interface, enter the keywords port-channel then a
number.
● For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then
the slot/port information.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a backup interface for this interface, enter the keyword backup.
NOTE: This command also enables you to view information corresponding to a
range of ports.
● For physical interfaces, you can specify multiple ports as slot/port-range.
For example, if you want to display information corresponding to all ports
between 1 and 4, specify the port range as show interfaces interface-
type 1/1 - 4.
● For port–channel interfaces, you can specify multiple ports as port-range.
For example, if you want to display information corresponding to all ports
between 1 and 4, specify the port range as show interfaces port—
channel 1 - 4.
stack-unit unit-id (OPTIONAL) Enter the keywords stack-unit then the stack member number.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.9(0.0) Added support to display the interface configurations corresponding to a range of
ports.
9.8(2.0) Introduced on the S3100 series.
Interfaces 665