Administrator Guide
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S-Series.
Example
DellEMC# rmdir nfsmount:/nfs-mountpoint/guest
Proceed to remove the directory [confirm yes/no]: yes
Related
Commands
● mkdir – create a directory.
upgrade system
Upgrade the Dell EMC Networking OS image. To upgrade the boot flash or boot selector image, use the upgrade boot
command.
Syntax
upgrade system {flash: | ftp: | nfsmount: | scp: | stack-unit {stack-unit-
id | all} | tftp: | usbflash:} file-url {A: |B:}
Parameters
system Enter the keyword system to upgrade the operating system (OS) image.
flash:
file-url
Enter the keyword flash: and specify the location of the image file in the
format //directory-path or press Enter to launch a prompt sequence.
ftp:
file-url
Enter the keyword ftp: and specify the location of the image file in the format //
userid:password@host-ip/filepath or press Enter to launch a prompt
sequence.
nfsmount://
<mount-point>/
filepath
Enter the keyword nfsmount: and specify the location of the image file in the
format //<mount-point>/filepath.
scp:
file-url
Enter the keyword scp: and specify the location of the image file in the format
userid:password@host-ip/filepath or press Enter to launch a prompt
sequence.
stack-unit
stack-
unit-id
Enter the keyword stack-unit and specify the stack-unit ID to sync the image
to that stack-unit.
stack-unit all Enter the keyword stack-unit followed by the keyword all to sync the image
on all stack-units.
tftp:
file-url
Enter the keyword tftp: and specify the location of the image file in the
format //host-ip/filepath or press Enter to launch a prompt sequence.
usbflash:
file-
path
Enter the keyword usbflash: and specify the location of the source file in the
format //directory-path to upgrade form an external flash device or press
Enter to launch a prompt sequence.
A: | B: Specify the flash partition of the operating-system image to be upgraded.
File Management 65