Administrator Guide

Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
DellEMC# clear dampening gigabitethernet 1/10
Clear dampening counters on TeGi 1/10 [confirm] y
DellEMC#
Related
Commands
● show interfaces dampening — display interface dampening information.
● dampening — configure dampening on an interface.
combo-port-type
You can pre-provision the medium of combo ports as copper or fiber.
Syntax
combo-port-type{copper | fiber}
Parameters
copper Enter the keyword copper to provision the combo port as a copper port.
fiber Enter the keyword fiber to provision the combo port as a fiber port.
Defaults None
Command Modes INTERFACE
Command
History
Version Description
9.11(0.0) Introduced on the N20xx and N30xx series port extenders.
9.10(0.0) Introduced on the S3100 series.
Interfaces 613