Administrator Guide

VLT DOMAIN Mode
To enable and configure the VLT domain protocol, use VLT DOMAIN mode. For more information, see Virtual Link Trunking
(VLT).
To enter VLT DOMAIN mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the vlt domain command, and then the VLT domain number. The prompt changes to include conf-vlt-domain.
You can return to CONFIGURATION mode by entering the exit command.
VRRP Mode
To enable and configure Virtual Router Redundancy Protocol (VRRP), use VRRP mode. For more information, see Virtual Router
Redundancy Protocol (VRRP).
To enter VRRP mode:
1. To enable VRRP globally, verify that you are logged in to CONFIGURATION mode.
2. Enter the vrrp-group command, and then enter the VRRP group ID. The prompt changes to include conf-if-
interface-type-slot/port-vrid-vrrp-group-id.
54 CLI Basics