Administrator Guide

interface type Enter the keyword interface then the type of interface to which the host is
connected:
● For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then
the slot/port information.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
lease time Enter the keyword lease then the amount of time the IP address are leased. The
range is from 1 to 4294967295.
Defaults None
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(1.0) Enhanced the command to map multiple IP addresses to one MAC address on the
S4810 and S4820T.
9.13(0.0) Enhanced the command to map multiple IP addresses to one MAC address on the
S5048F–ON.
9.13(0.0) Enhanced the command to map multiple IP addresses to one MAC address.
Enhanced to support DHCP snooping in a VLT setup.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series and S-Series.
Usage
Instructions
You can map multiple IP addresses to the same MAC address.
Related
Commands
● show ip dhcp snooping — display the contents of the DHCP binding table.
524 Dynamic Host Configuration Protocol (DHCP)