Administrator Guide

show ip bgp extcommunity-list
View information on all routes with Extended Community attributes.
Syntax
show ip bgp [vrf vrf-name] [ipv4 {multicast | unicast} | ipv6 unicast]
extcommunity-list [list name]
Parameters
vrf vrf-name (OPTIONAL) Enter the keywords vrf and then the name of the VRF to view
information on all routes with extended community attributes corresponding to that
VRF.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword multicast to
view information related only to ipv4 multicast routes.
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view information only related
to ipv4 unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the keyword unicast to view
information related only to ipv6 unicast routes.
list name Enter the extended community list name you wish to view. The range is 140
characters.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
To view the total number of COMMUNITY attributes found, use the show ip bgp summary command.
The text line above the route table states the number of COMMUNITY attributes found.
The show ip bgp community command without any parameters lists BGP routes with at least one
BGP community attribute and the output is the same as for the show ip bgp command output.
426 Border Gateway Protocol