Administrator Guide

neighbor soft-reconfiguration inbound
Enable soft-reconfiguration for BGP.
Syntax
neighbor {ip-address | peer-group-name} soft-reconfiguration inbound
To disable, use the no neighbor {ip-address | peer-group-name} soft-
reconfiguration inbound command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to disable or enable all routers within the peer
group.
Defaults Disabled
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.4.1.0 Introduced.
Usage
Information
This command enables soft-reconfiguration for the BGP neighbor specified. BGP stores all the updates
the neighbor receives but does not reset the peer-session.
You cannot set this configuration for a peer that is associated with a peer group. Similarly, you cannot
associate a peer to a peer group if that peer is already configured with these settings.
CAUTION: Inbound update storage is a memory-intensive operation. The entire BGP update
database from the neighbor is stored in memory regardless of the inbound policy results
applied on the neighbor.
Related
Commands
● show ip bgp neighbors — display routes received by a neighbor.
400 Border Gateway Protocol