Manualshelf

Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series
341342343344345346347348349350
Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
When a BGP cluster contains only one route reflector, the cluster ID is the route reflector’s router ID. For
redundancy, a BGP cluster may contain two or more route reflectors. Assign a cluster ID with the bgp
cluster-id command. Without a cluster ID, the route reflector cannot recognize route updates from
the other route reflectors within the cluster.
The default format for displaying the cluster-id is dotted decimal, but if you enter the cluster-id as an
integer, it is displayed as an integer.
This command automatically restarts the BGP instance for the configuration to take effect.
Related
Commands
● bgp client-to-client reflection — enable route reflection between the route reflector and clients.
● neighbor route-reflector-client — configure a route reflector and clients.
● show ip bgp cluster-list — view paths with a cluster ID.
bgp confederation identifier
Configure an identifier for a BGP confederation.
Syntax
bgp confederation identifier as-number
To delete a BGP confederation identifier, use the no bgp confederation identifier as-
number command.
Parameters
as-number
Enter the AS number. The range is from 0 to 65535 (2 byte), from 1 to
4294967295 (4 byte), or from 0.1 to 65535.65535 (dotted format).
Defaults Not configured.
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Border Gateway Protocol 349