Administrator Guide

Parameters
ipv4 | mac Enter the keyword ipv4or mac to identify the access list type to resequence.
access-list-name Enter the name of a configured IP access list, up to 140 characters.
StartingSeqNum Enter the starting sequence number to resequence. The range is from 0 to
4294967290.
Step-to-
Increment
Enter the step to increment the sequence number. The range is from 1 to
4294967290.
Defaults None
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series (IPv4).
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names
were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage
Information
When all sequence numbers are exhausted, this feature permits re-assigning a new sequence number to
entries of an existing access-list.
seq
Assign a sequence number to a deny or permit filter in an extended IP access list while creating the filter.
Syntax
seq sequence-number {deny | permit} {ip-protocol-number | icmp | ip | tcp |
udp} {source mask | any | host ip-address} {destination mask | any | host
ip-address} [operator [portnumber ]] [ttl operator] [count [byte] | log]
[dscp value] [ecn value] [fragments] [monitor [session-ID]] [no-drop]
[order]
Parameters
sequence-
number
Enter a number from 0 to 4294967290.
216 Access Control Lists (ACL)