Administrator Guide

NOTE: This command supports Loopback interfaces EE3 and EF series route processor modules
(RPMs). This command does not support Loopback interfaces ED series RPMs and S-Series
Loopback interfaces.
NOTE: If you apply outbound(egress) IPv6 ACL on a switch port, the filter applies only for routed
traffic egressing out of that port.
In the Dell EMC Networking OS versions prior to 9.13(0.0), the system does not install any of your ACL
rules if the available CAM space is lesser than what is required for your set of ACL rules. Effective with
the Dell EMC Networking OS version 9.13(0.0), the system installs your ACL rules until all the allocated
CAM memory is used. If there is no implicit permit in your rule, the Dell EMC Networking OS ensures that
an implicit deny is installed at the end of your rule. This behavior is applicable for IPv4 and IPv6 ingress
and egress ACLs.
One of the usage scenarios for using the layer3 keyword at the VLAN level, is to avoid ACL being applied
on the L2 traffic which comes in via ICL.
NOTE: The usage scenario listed above is one of many other usage scenarios.
ip control-plane egress-filter
Enable egress Layer 3 ACL lookup for IPv4 CPU traffic.
Syntax
ip control-plane egress-filter
Defaults Not enabled.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
show ip accounting access-list
Display the IP access-lists created on the switch and the sequence of filters.
Syntax
show ip accounting {access-list access-list-name | cam_count} interface
interface [vrf vrf-name]
188 Access Control Lists (ACL)