Administrator Guide

Version Description
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.0 Introduced on the E-Series.
Related
Commands
● radius-server host — configure a RADIUS host.
rate-limit
Configure NAS to allow or reject RADIUS dynamic authorization (DA) packets based on the configurable rate limit value.
Syntax
rate-limit packets per minute
To undo the configuration, enter the no rate-limit command.
Defaults 30 packets per minute.
Parameters
packet per
minute
Enter the number of packets that you want processed per minute. The range is
between 10 to 60 packets per minute.
Command Modes
● CONF-DYNAMIC-AUTH
Usage
Information
● Packets are dropped after number of packets reaches the configured rate-limit.
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.14(1.0) Introduced on the S4810 and S4820T.
9.13(0.0) Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000,
S6010–ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and
MXL.
replay-protection-window
Configure replay protection window period to drop the duplicate packets.
Syntax
replay-protection-window minutes
To undo the configuration, enter the no replay-protection-window command.
Defaults 5 Minutes.
Parameters
minutes Enter the number of minutes to drop the packets. The range is from 1 to 10
minutes.
Command Modes
● CONF-DYNAMIC-AUTH
Usage
Information
● Duplicate packets are dropped within replay-protection-window period if packet has same source IP
address, source UDP port and identifier.
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
1386 Security