Administrator Guide

Version Description
pre-6.2.1.0 Introduced on the E-Series.
da-rsp-timeout
Configure timeout value for the back end task to respond to DAC requests.
Syntax
da-rsp-timeout minutes
To undo the configuration, enter the no da-rsp-timeout command.
Defaults 10 Minutes.
Parameters
minutes Enter the time out value.
Command Modes
● CONF-DYNAMIC-AUTH
Usage
Information
● Time for DAS to wait before the back end response is received.
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.14(1.0) Introduced on the S4810 and S4820T.
9.13(0.0) Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000,
S6010–ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and
MXL.
disconnect-user
Configure NAS to allow or reject DM requests corresponding to AAA users-sessions coming from the DAC.
Syntax
disconnect-user
To undo this configuration, enter the no disconnect-user command.
Defaults Enabled.
Command Modes
● CONF-DYNAMIC-AUTH
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.14(1.0) Introduced on the S4810 and S4820T.
9.13(0.0) Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000,
S6010–ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and
MXL.
Security 1375