Administrator Guide

match ip vrf
Uses a VRF as the match criterion for an L3 class map.
Syntax
match ip vrf vrf-id
To remove VRF as the match criterion, use the no match ip vrf vrf-id command.
Parameters
vlan vlan-id Enter the keyword vrf and then the ID of the VRF. The range is from 1 to 511.
Defaults none
Command Modes CONF-CLASS-MAP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5.(0.1) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z-Series.
Usage
Information
To access this command, enter the class-map command. After the class map is identified, you can
configure the match criteria.
Use this command to match an IP class-map against a single VRF ID .
Related
Commands
● class-map — identifies the class map.
match mac access-group
Configure a match criterion for a class map, based on the contents of the designated MAC ACL.
Syntax
[seq sequence number] match mac access-group {mac-acl-name}
Parameters
mac-acl-name Enter a MAC ACL name. Its contents is used as the match criteria in the class map.
Defaults none
Command Modes CLASS-MAP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced the seq option for the class-map on all the Dell EMC Networking OS
platforms.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
Quality of Service (QoS) 1251