Administrator Guide

Version Description
9.10(0.0) Introduced on the S3148.
9.10(0.0) Increased the stacking range to 12 units in S3100 series.
9.8(2.0) Introduced on the S3100 series.
Usage
Information
The following table describes the output fields of the show power inline command:
Field Description
Interface Displays the line card or the interface slot and port number.
Inline Power
Allocated
Displays the amount of power allocated to the port.
Inline Power
Consumed
Displays the amount of power consumed by the connected device.
Class
Displays the power classification of the connected device. If the device is powered
up properly, it displays Class 0, 1, 2, 3, or 4. Displays the following under different
conditions:
● NO_DEVICE if no device is present.
● LEGACY if a legacy device is connected.
● PD_S/C if a short-circuit condition is detected.
● PD_OVRLD if overload condition is detected.
Device Type Displays whether the device is Type 1 or Type 2.
PoE Port Priority Displays the power configured for the port (default is low). See power inline
priority.
LLDP Support Displays the power requested is via LLDP-MED extended power-via-mdi TLV or
IEEE 802.3at power-via-mdi TLV.
Example
DellEMC#show power inline stack-unit 1
Global inline power Threshold : 10
Power Reserved for inline Power: 95W
Total Inline Power Consumed: 0W
Remaining inline power Available: 95W
Power Management Mode: Class
Interface Inline Power Inline Power Class Device PoE Port
LLDP
Max / Alloc Consumed Type Priority
Support
(Watts) (Watts)
--------- ------------ ------------ ------- ------ --------
------
Gi 1/1 0.00 /0.00 0.00 NO_DEVICE -
high
DellEMC#
Power over Ethernet (PoE) 1205