Administrator Guide

% Error: Power to stack-unit 1 is in suspended state.
DellEMC#
show power detail
You can use this command to display the inline power consumption details for a specified stack unit.
Syntax
show power detail {stack-unit unit number}
Parameters
stack-unit unit
number
Enter the stack-unit keyword and the unit number. Range is 1 to 12.
Defaults None
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
EMC Networking OS Command Line Reference Guide.
The following is a list of the DellEMC Networking OS version history for this command.
Version Description
9.10(0.0) Introduced on the S3148.
9.10(0.0) Increased the stacking range to 12 units in S3100 series.
9.8(2.0) Introduced on the S3100 series.
Example
DellEMC#show power detail stack-unit 1
Unit Total System Redundancy Inline Inline Inline Inline Inline
Power Power Power Power Power Power Power Power
Available Consumed Consumed Threshold Available Allocated Consumed Remaining
(Watts) (Watts) (Watts) (%) (Watts) (Watts) (Watts) (Watts)
-------------------------------------------------------------------------------
1 1100 150 0 10 95 0 0 95
DellEMC#
show power inline
You can use this command to display the PoE power allocation on a specified stack unit or on an interface.
Syntax
show power inline {stack-unit unit number | interface interface SLOT/PORT
[/SUBPORT] }
Parameters
stack-unit unit
number
Enter the keyword stack-unit and the stack unit number Range is from 1 to 12.
interface
interface SLOT/
PORT [/
SUBPORT]
Enter the interface keyword, and specify the interface type followed by the
SLOT/PORT [/SUBPORT] numbers.
Defaults None
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant
DellEMC Networking OS Command Line Reference Guide.
The following is a list of the DellEMC Networking OS version history for this command.
1204 Power over Ethernet (PoE)