Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

1201

Command Modes CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant

DellEMC Networking OS Command Line Reference Guide.

The following is a list of the DellEMC Networking OS version history for this command.

Version Description

9.10(0.0) Introduced on the S3148.

9.10(0.0) Increased the stacking range to 12 units in S3100 series.

9.8(2.0) Introduced on the S3100 series.

Usage

Information

The power inline mode command allows you to manage inline power supply on the stack unit. You

can configure class or static mode to manage inline power in a stack unit.

When class mode is configured, maximum power for the particular class of device is allocated. Class

mode supports power allocation via Layer 2 classification and power negotiation by Link Layer Discovery

Protocol (LLDP) 802.3at standard . When static mode is configured, the inline power is allocated based

on the actual power consumption by the powered device. Power negotiation via LLDP is not supported in

static mode.

Example

Example for static mode:

DellEMC(conf)#power inline mode stack-unit 1 static

DellEMC#show power inline stack-unit 1

Global inline power Threshold : 10

Power Reserved for inline Power: 95W

Total Inline Power Consumed: 0W

Remaining inline power Available: 95W

Power Management Mode: Static

Interface Inline Power Inline Power Class Device PoE Port

LLDP

Max / Alloc Consumed Type Priority

Support

(Watts) (Watts)

--------- ------------ ------------ ------- ------ --------

------

Gi 1/1 30.00/0.00 0.00 NO_DEVICE -

high

DellEMC#

Example for class mode:

DellEMC(conf)#power inline mode stack-unit 1 class