Administrator Guide

line
Enable and configure console and virtual terminal lines to the system. This command accesses LINE mode, where you can set
the access conditions for the designated line.
Syntax
line {aux 0 |console 0 | vty number [end-number]}
Parameters
aux 0 Enter the keyword aux 0 to configure the auxiliary terminal connection.
console 0 Enter the keyword console 0 to configure the console port. The console option
is <0-0>.
vty number Enter the keyword vty then a number from 0 to 9 to configure a virtual terminal
line for remote sessions. The system supports 10 remote sessions.
end-number (OPTIONAL) Enter a number from 1 to 9 as the last virtual terminal line to
configure. You can configure multiple lines at one time.
Defaults Not configured
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command
Usage
Information
You cannot delete a terminal connection.
Related
Commands
● access-class — restricts the incoming connections to a particular IP address in an IP access control
list (ACL).
● password — specifies a password for users on terminal lines.
112 Control and Monitoring