Administrator Guide

track interface ip routing
Configure object tracking on the routing status of an IPv4 Layer 3 interface.
Syntax
track object-id interface interface ip routing
To return to the default setting, use the no track object-id command.
Parameters
object-id Enter the ID number of the tracked object. The range is 1 to 500.
interface Enter one of the following values:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a tunnel interface, enter the keyword tunnel.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON. Added support for tunnel interface.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Usage
Information
Use this command to create an object that tracks the routing state of an IPv4 Layer 2 interface:
● The status of the IPv4 interface is UP only if the Layer 2 status of the interface is UP and the
interface has a valid IP address.
● The Layer 3 status of an IPv4 interface goes DOWN when its Layer 2 status goes down (for a Layer 3
VLAN, all VLAN ports must be down) or the IP address is removed from the routing table.
Related
Commands
● show track – display information about tracked objects, including configuration, current state, and
clients which track the object.
● track interface line-protocol – configure object tracking on the line-protocol state of a Layer 2
interface.
track interface line-protocol
Configure object tracking on the line-protocol state of a Layer 2 interface.
Syntax
track object-id interface interface line-protocol
1026 Object Tracking